3 AXIS (TB6560) CNC DRIVER BOARD 4 STEPPER MOTOR MILL CNC ROUTER

3-AXIS TB6560 CNC DRIVER BOARD 4 STEPPER MOTOR (ROUTER,MILL)  

     3-AXIS (TB6560) CNC STEP MOTOR DRIVER 's features:

• HUGE improvements from TA8435 based boards **
• Resolution: Full step, 1/2, 1/8,1/16 selectable via switch for each axis.
• Absolute maximum ratings: 40VDC @ 3.5 amps(peak)/phase motor output per axis *
• PC parallel port DB25 connector has being installed onboard.
• Adjustable motor current at 100%, 75%, 50%, 20% of full current by on-board switch
• Supports different 4 Wire, 6 Wire and 8 Wire stepper motors for 3 axis drive.
• Built-in overheat protection circuit in TB6560
• This board is tested through KCAM, Mach 2/3, touborCNC CNC software.
• This board has been used in different design 3D engrave machines, millers, routers.
• Include manual control circuit to test all 3 axis step motors manually
• Step Current^(r) extension board (Optional: See my other auctions): Step Current technology is used to decrease the current upto 1/2, when motors are in idle for all axis so as to protect expensive step motor and driver board for long time running.

   * See TB6560 Datasheet by TOSHIBA. The full current is preset at 2.5A by resisters for this board (you can adjust it by changing them).
　

   **Comparison between TA7835 (used in Univelop V1.0 CNC driver) and TB6560 (used in V2.0 CNC driver board):

Contents:

• one 3 axis CNC driver board

• Manual Download

• Step Current Extension board.