5 AXIS (TB6560) CNC STEP MOTOR DRIVER

    5 AXIS CNC STEP MOTOR DRIVER 's features:

• HUGE improvements from TA8435 based boards **
• Resolution: Full step, 1/2, 1/8,1/16 selectable via switch for each axis.
• Absolute maximum ratings: 40VDC @ 3.5 amps(peak)/phase motor output per axis *
• PC parallel port DB25 connector has being installed onboard.
• Adjustable motor current at 100%, 75%, 50%, 20% of full current by on-board switch
• Supports different 4 Wire, 6 Wire and 8 Wire stepper motors for 3 axis drive.
• Built-in overheat protection circuit in TB6560
• This board is tested through KCAM, Mach 2/3, touborCNC CNC software.
• This board has been used in different design 3D engrave machines, millers, routers.
• Double Buffer for Interface and Driver for reliable Driving and  protecting Computer and driver board.
• 1KV, 10 Mbps high speed Optocoupler for full elimination to protect Computer and driver board.
• Step Current^(r) Technology included: Step Current technology is used to decrease the current upto 1/2, when motors are in idle for all axis so as to protect expensive step motor and driver board for long time running.

  * See TB6560 Datasheet by TOSHIBA. The full current is preset at 2.5A by resisters for this board (you can adjust it by changing them).
     **Comparison between TA7835 (used in Univelop V1.0 CNC driver) and TB6560 (used in V2.0 CNC driver board):

	V 1.0 (TA7835)	V 2.0 (TB6560)
IC Overheat protection	N/A	Built-in
Current Adjustable	100%/50%	100%/75%/50%/20%
Current for motor	Peak 2.5A	Peak 3.5A [*]
Voltage for motor	Max 35V	Max 40V [*]
Micro stepping	1 – 1/8	1 – 1/16
Frequency (fOSC)	Max 80kh	Max 600khz

This auction provides you :

• One 5-axis CNC Interface Board
• Five 1-Axis CNC driver boards
• 5 Connection cables
• a Manual.

We also provide additional 1-axis driver board, interface board, cables for extension of our 5 axis driver boards, and other components.

Thanks.